PRODUCTS CENTER
Enquiry hotline
News information
0086-574-88928658
What should we pay attention to when processing precision hardware parts?
Abstract：1. Check whether the moving part is filled with lubricating oil before mechanical work, and then start and check whether the clutch and brake are normal, and run the machine empty for 1-3 minutes, and strictly prohibit operation when there is a mechanical failure.
1. Check whether the moving part is filled with lubricating oil before mechanical work, and then start and check whether the clutch and brake are normal, and run the machine empty for 1-3 minutes, and strictly prohibit operation when there is a mechanical failure.
2, work to maintain the correct posture, to have sufficient mental coping with the work, if found unwell immediately leave the work, and reflect to the leader. The operation must be concentrated, it is strictly forbidden to talk, cooperate with each other, the operator should not operate in a state of irritability and fatigue, so as to avoid accidents and ensure the safety of operation. All employees should check whether their clothing meets the job requirements before entering the job. Do not wear slippers, high heels and clothing that affect safety. Wear a helmet if you have long hair.
3. When replacing the mold, first turn off the power, and only after the press movement department stops running, can the installation and debugging of the mold begin. After installation and adjustment, move the flywheel by hand to test twice, check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the holder ring is in a reasonable position.
4, must wait for other personnel to leave the mechanical work area, and take away the debris on the workbench, before starting the power to start the machine.
5, mechanical work, do not extend the hand into the slider working area, do not use the hand to take, release the work. Standard tools must be used when taking and releasing parts in the die. If the machine has abnormal sound or machine failure, the power switch should be turned off immediately for inspection. After the machine is started, one person shall carry the material and operate the machine. Other people shall not press the electric building or step on the foot switch plate, nor shall they put their hands into the mechanical working area or touch the moving part of the machine with their hands.
6, after work, should turn off the power, and sort out the finished products, side materials and debris on the post, to ensure that the working environment is clean and safe.
2, work to maintain the correct posture, to have sufficient mental coping with the work, if found unwell immediately leave the work, and reflect to the leader. The operation must be concentrated, it is strictly forbidden to talk, cooperate with each other, the operator should not operate in a state of irritability and fatigue, so as to avoid accidents and ensure the safety of operation. All employees should check whether their clothing meets the job requirements before entering the job. Do not wear slippers, high heels and clothing that affect safety. Wear a helmet if you have long hair.
3. When replacing the mold, first turn off the power, and only after the press movement department stops running, can the installation and debugging of the mold begin. After installation and adjustment, move the flywheel by hand to test twice, check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the holder ring is in a reasonable position.
4, must wait for other personnel to leave the mechanical work area, and take away the debris on the workbench, before starting the power to start the machine.
5, mechanical work, do not extend the hand into the slider working area, do not use the hand to take, release the work. Standard tools must be used when taking and releasing parts in the die. If the machine has abnormal sound or machine failure, the power switch should be turned off immediately for inspection. After the machine is started, one person shall carry the material and operate the machine. Other people shall not press the electric building or step on the foot switch plate, nor shall they put their hands into the mechanical working area or touch the moving part of the machine with their hands.
6, after work, should turn off the power, and sort out the finished products, side materials and debris on the post, to ensure that the working environment is clean and safe.
